Product Introduction
ADM-4108R ee 8-way relay switching volume output module, lëu bï ya luɔ̈ɔ̈i në signal control de industrial field equipment. 8-way A-type (often open) relay output, relay capacity is 3A @250VAC/30VDC. Communication interface adopts RS-485 interface, support the standard MODBUS RTU protocol, can be directly connected to configuration software, PLC, DCS industrial control touchscreen.
Specifications
(1), Switch volume output
1. output channel: 8 way A type (often open) relay output (can customize 5 way relay output)
Voltage: 0 ~ 250VAC wala 0 ~ 30VDC
3. Load current: 3A
((2))
1. Protokol: MODBUS-RTU
2. Interface type: Optical isolation RS-485 interface
3. Interface Protection: 15KV ESD Protection, 1500V Isolation Protection
4. Porter Rate: 1200bps, 2400bps, 4800bps, 9600bps, 19200bps
38400bps, 57600bps, 115200bps.
5. Verification bit: No verification, double verification, odd verification
6.Default parameter: 9600, N， 8, 1 (Porter Rate ku Verification Bit lëu bï ya waar)
(3) Parameters sistem
1. Module size: 104mm x72mmx26mm
2.Installation: 35mm DIN rail install
3. Luɔi: Temperature: -20 ~ 70 ℃ Humidity: 0-95%, no condensation
Power: DC9 ~ 30V ka tɔ̈u 3W
Module Indicator Definition
1. POWER: Power status indicator, always bright/power supply normal
COMM: RS-485 interface communication indication, bright/module is sending and receiving data. COMM: RS-485 interface communication indication, bright/module is sending and receiving data. COMM: RS-485 interface communication indication, bright/module is sending and receiving data.
3. RO0 ~ RO7: relay action indicator, light up / relay closed
Luɔ̈ɔ̈i paramètre de communication default
1.To yï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yïï yï y
2.When INIT and VS-pin are disconnected, after starting the module user uses the set communication parameters to communicate, when factory the module parameters are (9600, N, 8, 1), the module address is 01. INIT and VS-pin are disconnected, after starting the module user uses the set communication parameters to communicate, when factory the module parameters are (9600, N, 8, 1), the module address is 01.